Scotsman SCE275 Bedienungsanleitung PDF herunterladen (Seite 21)

1. Remove and discard all ice from the bin. If the

cleaning was pre-planned, the ice machine could

be switched off the night before to minimize waste.

2. Remove the left front grill.

3. Push and release the Harvest button (this

releases any ice that may be on the evaporators

and warms them up).

4. Wait for the machine finish the Harvest cycle the

machine will switch off). The Off light will be

blinking.

5. Push and release the Clean button. The Clean

indicator light will be blinking and the pump will

re-start.

6. Pour 8 ounces (235 ml) of Scotsman Ice

Machine Cleaner into the reservoir water (below

the evaporators).

7. After the ice machine cleaner has circulated for

10 minutes, push and release the Clean button.

This starts the rinse process. The Clean indicator

light will be ON. Note: The rinse flushes any

residual cleaner out of the ice machine’s water

system.

8. Continue the rinsing process for 20 minutes,

then push the off button to switch the machine off.

Go thru steps 9-23 to sanitize the ice machine

water system or go to step 24 to finish the cleaning

process.

9. Mix 2 gallons of Sanitizer solution. Follow local

codes for Sanitizer.

Note: A possible sanitizing solution may be made

by mixing 1 ounce of liquid household bleach with

2 gallons of warm (95-115

F.) potable water.

10. Locate the two three-prong-head bolts holding

the hood to the bin and remove them.

11. Remove the hood from the ice machine.

12. Locate the evaporator cover and remove the

four thumb screws that hold it to the machine.

Remove the evaporator cover.

13. With rubber gloves and a clean cloth or spray

bottle, use the sanitizer solution to thoroughly

wash or spray all interior surfaces of the ice

storage bin, hood, knobs, and bin door with the

sanitizing solution. Wash the joint between the

hood and bin with the sanitizing solution. Also

wash or spray the evaporator cover, the inside

back wall of the freezing compartment, the top of

the water distributors, the exterior surface of the

reservoir, and the troughs with the sanitizing

solution.

14. Return the evaporator cover to its original

position and secure it with the original thumb

screws.

15. Return the hood to its normal position and

secure it to the machine with the original bolts.

16. Pull cube deflector out of the reservoir.

17. Push and release the Clean button again.

18. Pour 11 ml or 2.25 teaspoons of liquid

household bleach, or an amount of locally

approved sanitizer of sufficient strength to create a

sanitizing solution equal to 200 ppm of sodium

hypochlorite in .75 gallons (2.8 l), into the reservoir

water.

19. Thoroughly immerse the cube deflector in a

container of sanitizing solution.

20. After the sanitizing solution has circulated for

10 minutes, push and release the Clean button.

This starts the rinse process.

21. Continue the rinsing process for 20 minutes

then push the off button to switch the machine off.

22. Repeat steps 10-15.

23. Return the cube deflector to its original

position.

24. Push and release the Freeze button.

25. Return the front grills to their normal positions

and secure to the machine with the original

screws.

SCE275

November 2004

Page 21

Sanitizing and Cleaning In Place Cleaning of the Ice Machine Water System:

Ice Machine Cleaner

contains acids. These

compounds may cause

burns.

If swallowed, DO NOT

induce vomiting. Give large

amounts of water or milk.

Call Physician immediately.

In case of external contact,

flush with water.

KEEP OUT OF THE

REACH OF CHILDREN.

Pouring Ice Machine Cleaner

into the Reservoir

Cube Deflector

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

Scotsman SCE275 Bedienungsanleitung Seite 21

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Scotsman SCE275