Scotsman SCE275 Bedienungsanleitung PDF herunterladen (Seite 22)

Additional Maintenance

Water Distributors

It may become necessary to remove the water

distributors from the top of the evaporator and

clean (de-mineralize) them outside of the ice

machine.

1. Remove right front grill.

2. Push and release the OFF button.

3. Remove the machine’s hood & door.

4. Reach over the water distributors and pull the

hose off.

5. Push the two water distributors to the right until

the left end clears its retaining slot, then pull the

left end up.

6. Repeat for the back one.

7. Examine the top of the evaporators. The Water

Distribution Channels must be free from mineral

build up. If build up is evident, scrub the channels

with Scotsman Ice Machine Cleaner and a plastic

bristle brush.

8. Examine the water distributors. Although they

are made of a material that is resistant to mineral

build up, some may be present. Soak or scrub the

distributors in or with a solution of Scotsman Ice

Machine Cleaner and warm potable water.

9. Return the water distributors to their normal

installed position.

9a. Snap the two distributors onto the water

manifold. Place them on the back evaporator, right

end first. Push the distributors far enough to the

right until the left end clears the retaining slot, then

release. Check that the distributors are seated

properly.

9b. Place the water hose onto the back water

distributors.

9c. Repeat for the front evaporator.

10. Reverse the above steps to reassemble.

The storage bin must be cleaned regularly to

maintain a sanitary environment. Once a week

cleaning of the door and door frame with soap and

water, a hot water rinse and an air dry is a basic

procedure. Scale that may form on the plastic liner

can be removed by scrubbing the surface with a

mixture of Scotsman Ice Machine Cleaner and hot

water. Remove any scale prior to cleaning.

To Remove Scale From Bin Interior:

1. Mix a cleaning solution of 4 ounces of Ice

Machine Cleaner to 4 pints of hot (95

F.-110

F.)

water.

2. Using rubber gloves, dip a nylon scouring pad

into the cleaning solution and scrub the scale off

the interior of the bin.

3. After the scale has been removed, rinse all

surfaces inside the bin with clean, potable water.

To Drain Reservoir Completely (if desired):

1. Remove front panel.

2. Push and hold the Off button.

3. Remove screw holding reservoir cover, pull inlet

tube out of reservoir cover, lift cover out of

machine.

4. Unplug water pump connection, remove ground

screw.

5. Remove float from float stem.

6. Unplug water level sensor.

7. Lift pump and sensor out of the machine.

8. Pull up on standpipe to release water.

9. Reverse steps 2-8 to reassemble.

Note: Be certain that the float is fully re-seated on

the stem and the water pump bracket is positioned

properly on the base.

Make sure that the stand pipe is properly seated.

10. Push and release Freeze button.

11. Replace front panel.

SCE275

January 2003

Page 22

Removal of Water Distributors

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

Scotsman SCE275 Bedienungsanleitung Seite 22

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Scotsman SCE275