Scotsman SCE275 Bedienungsanleitung PDF herunterladen (Seite 30)

Removal and Replacement: AutoIQ Controller

Begin by disconnecting the electrical power.

1. Remove 2 screws and the right front grill.

2. If the machine is operating, push and hold the

Off button until the machine switches off.

3. Unplug or disconnect electrical power.

4. Remove the one screw at the right end of the

AutoIQ Controller.

5. Pivot the controller up and away from its

mounting bracket.

6. Unplug all connecting wires.

7. Reverse steps 6-1 to replace the controller.

Electrical Box and Components

Below the bin on the left side of the chassis is a

sheet metal box containing the transformer,

compressor contactor, compressor relay, start

capacitor and run capacitor.

This box may only be accessed by removing the

hood and bin. After that:

1. Remove the cap screw securing the electrical

box to the ice machine chassis.

2. Pull the electrical box forward to release it from

the tab at the back of the box.

3. The box may now be placed in a horizontal

position for better service access.

Standpipe:

The overflow standpipe is located at the back of

the reservoir. The water pump and water level

sensor must be removed to get access to it.

The height of the standpipe is very important.

Measured from the top edge of the reservoir to the

very top of the standpipe, the distance should be:

SCE275

January 2003

Page 30

Electrical shock

hazard.

Electrical shock can

cause personal injury.

Disconnect power before

beginning to service

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Keine Kommentare

Scotsman SCE275 Bedienungsanleitung Seite 30