IntroductionThis manual includes:•Installation Information•Use And Care•Service Diagnosis•and Repair InformationA Service Parts Section is also includ
Reversing the Door SwingTOOLS NEEDED:516" wrench,14" wrench, flat puttyknife,To remove door from hinges:1. Unplug ice maker ordisconnect pow
Using The Ice MakerUnderstanding How Your Ice Maker WorksWhen you first start your ice maker, the water panwill fill and the system will rinse itself
Caring For Your Ice MakerPeriodically inspect and clean the ice maker to keepit operating at peak efficiency and to preventpremature failure of system
Cleaning the CondenserA dirty or clogged condenser:•Prevents proper airflow.•Reduces ice making capacity.•Causes higher than recommended operatingtemp
Cleaning the Interior Components1. Unplug ice maker or disconnect power.2. Open the storage bin door and remove any icethat is in the bin.3. Remove th
Cleaning Interior - continued8. Remove the two screws that hold the water pan inplace. Push down with one hand on the front of thepan while pulling fo
Vacation and Moving CareTo shut down the ice maker:1. Unplug ice maker or disconnect power.2. Remove all ice from storage bin.3. Shut off the water su
Before Calling for ServiceTry the solutions suggested here first in order toavoid the cost of an unnecessary service call.Unit does not runn Is the co
Technical Service DiagnosisCSW45July 1999Page 18Symptom Possible Cause Probable CorrectionUnit OffNo power to unitPlug unit itReset circuit breaker or
Technical Service DiagnosisJuly 1999Page 19CSW45Symptom Probable Cause Possible CorrectionLow ice making capacityDirty air cooled condenser Clean cond
SpecificationsJuly 2001Page 2CSW45Light SwitchCutter Grid CoverWater PanModel SerialNumber LabelIce Retainer BaffleLower Access PanelControl PanelIce
Technical InformationPerformance DataIce Bin ThermistorEvaporator ThermistorComponentsCSW45October 2005Page 20TemperatureSuction Pressure at Endof Fre
Electrical SequenceThe CSW45’s operation is controlled by an electronicboard. This board takes in data from two thermistors:The Ice Bin Thermistor and
Repair InformationCutting GridThe cutting grid rests on two shelves molded into thebin liner. It is also secured to the liner with twoscrews.1. Remove
Repair InformationWater SlideThe water slide is mounted to the front of theevaporator and diverts water to the reservoir. It isconnected to the evapor
Repair InformationWhen tilting the cabinet, be sure it is secure to avoidany possibility that it will tip too far back or fallforward.July 1999Page 24
Installing The Ice MakerUnpackingRemoving packaging materialsIMPORTANT: Do not remove any permanentinstruction labels inside your ice maker or the Tec
Electrical & LevelingBefore you move your ice maker into its finallocation, it is important to make sure you have theproper electrical connection:
To Adjust The Rear Wheel Height1. Using a14“ socket wrench, remove the sevenscrews from the rear access panel and carefully pullthe panel away from th
Connecting the Ice Maker to a Water SourceRead all directions carefully before you begin.IMPORTANT:•All installations must be in accordance with local
Water Connection - continued11. Unscrew the water valve inlet cover, and attachthe copper tubing with the compression sleeve andnut.NOTE: To prevent r
Connecting The DrainGravity drain systemConnect the drain pump hose (provided with theproduct) to your drain in accordance with all stateand local cod
Drain Pump Kit1. Remove rear cover.2. Remove old drain tube.3. Install new drain tube to bin (use old clamp).4. Install drain pump into machine. Caref
Kommentare zu diesen Handbüchern